Discharge of paper or film shreds in the disposal facility

How do stationary compactors for waste disposal of plastic or paper cuttings work?

Suction pipes are used, for example, to transport punching or cutting waste from a printing press via a pipe system to a waste disposal facility. The same applies to edge trim suction in plastic film production. The material waste is compressed in the stationary compactor and then transported to the transport container. The full container is transported away by truck.

Our solution

Suitable discharge bars with additional air duct are mounted in the best possible position in the drop chute.

For the detailed solution description of this application or a consultation on your application problem, click here:

Contact Us

Which Eltex components are used?

The following Eltex products have been installed and tested on site by our experts. If you would like to learn more or have any questions, please do not hesitate to contact us.

IONIZER ES51

The robust all-rounder with a large power input The VARIO IONIZER ES51 has 5 connections and works with proven Eltex technology. On the top side there is a LED display for the function and fault message. The device also has an analog interface. For a good ion balance, the device is available with and without parameter diode.

Weiterlesen

blueBAR R50

The robust all-rounder bar The VARIO discharge bar blueBAR R50 creates a significantly higher active discharge capacity than most discharge techniques. The isolated ground conductor enhances the E-field at the active tips, contributing to increased production and velocity of charge carriers. Thus, significantly more positive ions and free negative electrons are available than with conventional bars. At the same time, the bars have a high passive discharge capacity. The resistance-decoupled tips ensure good discharge performance and make the bar absolutely short-circuit and touch-proof.  

Weiterlesen

IONIZER ES53

Safe discharge also in the EX area The VARIO high-voltage power supply IONIZER ES53 and the associated Ex discharge bars are available for active discharge of electrostatic interference in hazardous areas. The IONIZER ES53 complies with the requirements of the Ex approval of the associated discharge bars (details in the operating instructions for the bars).

Weiterlesen

exBAR EXR5C

Safely discharged even in EX areas The exBAR EXR5C is operated with an AC voltage of 5 kV at 50...60 Hz and is approved for use in Group IIG and IID potentially explosive atmospheres. Corresponds to equipment category 2 (zone 1 operating equipment).  

Weiterlesen

Are you looking for a customized solution for your area?

We will be happy to advise you free of charge and discuss the possible next steps with you.